U Type Galvanized Punching Parts

Payment Type:L/C,T/T,D/P,Paypal

Incoterm:FOB,CIF,EXW

Min. Order:1 Piece/Pieces

Transportation:Ocean,Land,Air,Express

Port:TAICANG,NINGBO,SHANGHAI

Product Attributes
Supply Ability & Additional Information
Packaging & Delivery
Other information

Product Attributes

Model No.: Customization

Place Of Origin: China

Customization: Customization

Supply Ability & Additional Information

Packaging: BOX

Transportation: Ocean,Land,Air,Express

Supply Ability: SUPPLY100%

Port: TAICANG,NINGBO,SHANGHAI

Payment Type: L/C,T/T,D/P,Paypal

Incoterm: FOB,CIF,EXW

Packaging & Delivery

Selling Units:

Piece/Pieces

Package Type:

BOX

Galvanized Punching Parts are Metal Components that have undergone a galvanization process to enhance their corrosion resistance. These parts are typically manufactured by punching or stamping a sheet of galvanized steel or other metal alloy. The galvanization process involves coating the metal with a layer of zinc, which provides a protective barrier against rust and other forms of corrosion.1.1.3.1 The impact of materials on cutting and processing

Blanking requires that the board should have sufficient plasticity to ensure that the board does not crack during punching. Soft materials (such as pure aluminum, rust resistant aluminum, brass, copper, low-carbon steel, etc.) have good punching performance, and after punching, parts with smooth cross-section and small inclination can be obtained; Hard materials (such as high carbon steel, stainless steel, hard aluminum, superhard aluminum, etc.) have poor quality after punching, and have large cross-sectional unevenness, especially for thick sheet materials. For brittle materials, Thick Steel Plate tearing is prone to occur after punching, especially when the width is very small.
1.1.3.2 The influence of materials on bending processing
The Sheet Metal that needs to be bent into shape should have sufficient plasticity and a lower yield limit. Plates with high plasticity are less prone to cracking during bending. Plates with lower yield limit and lower elastic modulus have less rebound deformation after bending,Custom Sheet Metal making it easy to obtain accurately sized bending shapes. Materials with good plasticity such as low-carbon steel, brass, and aluminum with a carbon content of less than 0.2% are prone to bending and forming; Materials with high brittleness, such as phosphorus bronze (QSn6.5-2.5), spring steel (65Mn), hard aluminum, superhard aluminum, etc., must have a relatively large bending radius (r/t) during bending, otherwise cracking may occur during the bending process. Special attention should be paid to the selection of the hard and soft state of the material, which has a significant impact on the bending performance. For many brittle materials, bending can cause cracking or even bending fracture of the outer corner, and for some steel plates with high carbon content, if the hard state is selected, bending can also cause cracking or even bending fracture of the outer corner, Galvanized Corrugated Metal which should be avoided as much as possible 2023 05 05 9 54 50 Png